HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 67
Routing I/O Cables, Step 1.
View all HP Integrity Superdome SX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Figure 2-33 Routing I/O Cables Installing the System Setting Up the hp Integrity Superdome or hp 9000 Superdome Use the following procedure and guidelines to route cables through the cable groomer at the bottom rear of the cabinet. Step 1. Remove the cable access plate at the bottom of the groomer. Step 2. Beginning at the front of the cabinet, route the cables using the following pattern: 1. Route the first cable on the left side of the left-most card cage first. Route it under the PCI-X card cage toward the back of the cabinet and down through the first slot at the right of the cable groomer. 2. Route the second cable on the left side of the left-most card cage to the right of the first cable, and so on, until routing all of the cables in the card cage is complete. The number and width of cables vary from system to system. Use judgement and the customer's present and estimated future needs to determine how many cables should be routed through each cable groomer slot. 3. After routing the left most card cage at the front of the cabinet, route the cables in right-most card cage at the back of the cabinet. Begin with the right cable in the card cage and work toward the left. 4. After routing the cables in right-most card cage at the rear of the cabinet, return to the front of the system and route the cables in the next card cage to the right. Chapter 2 55