HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 70

Installing the System Connecting the MP to the Customer LAN Setting Customer IP Address NOTE The default IP address for the Customer LAN port on the MP is 192.168.1.1. To set the customer LAN IP address: Step 1. From the MP Command Menu prompt (MP:CM>), enter lc (for LAN Configuration). The screen displays the default values and asks if you want to modify them. It is a good idea to write down the information, as it may be required for future troubleshooting. If you are not already in the Command Menu, enter ma to return to the Main Menu, then enter cm When you enter lc, the following screen appears: Figure 2-35LAN Configuration Screen If the LAN software on the MP is working properly, it should see the message: "LAN status: UP and RUNNING." The value in the "IP address" field has been set at the factory. You will need to get the customer LAN IP addresses from the customer. NOTE The customer LAN IP address is designated LAN Port 0. Step 2. The prompt will ask if you want to modify the LAN port 0; enter y. The current Customer IP address is shown; then the following prompt appears: Do you want to modify it? (Y/[N]) Step 3. Enter y. Step 4. Enter the new IP address. The customer should provide this address for LAN Port 0. Step 5. Confirm the new address. Step 6. Enter the MP Network Name. 58 Chapter 2