HP Integrity Superdome SX1000 User Guide, Sixth Edition - HP Integrity Superdo - Page 114

Removing and Replacing Components Removing and Replacing the Front-End Power Supply Step 5. Re-attach the four heavy cables and two sense wires previously marked to the appropriate studs on the FEPS. Figure 3-16Re-attaching Power Leads and Cables Attach cables to these connectors Attach power cables and tighten 3/8-inch nuts Rear View of Cabinet Step 6. Slide the PDCA(s) into the FEPS and secure them by tightening the four T15 captive screws on each one. Step 7. Re-attach the cable groomer and left and right L brackets. Restoring Power to the Cabinet Step 1. Turn ON all breakers at the wall panel associated with the cabinet. Step 2. Power of the housekeeping voltage by turning off the cabinet breakers. Step 3. Boot all partitions following the procedures in Appendix B, "Powering On and Off the System." 102 Chapter 3