HP Scitex LX600 HP Designjet L65500 Printer and HP Scitex LX Printer Family - - Page 46

Problems with the ink sensor value, continue with step 2. If you think there are no air bubbles, press

Get HP Scitex LX600 PDF manuals and user guides View all HP Scitex LX600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

25. Remove the purger quick connector. Problems with the ink sensor value 1. There are three different cases that can cause a problem. ● The pressure sensor value is below a limit, which may vary depending on the volume of the supply. Probably there is an air bubble inside the cartridge connector tube column. Prepare the syringe again. Press OK and continue with step 2. ● The ink volume of the cartridge is too low to register on the pressure sensor. To ensure there are no air bubbles in the tube, you are recommended to purge again. Press BACK and continue with step 2. If you think there are no air bubbles, press OK and continue the process of purging the ISM tubes from where you were. 42 Chapter 7 Purge the ink system ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
25.
Remove the purger quick connector.
Problems with the ink sensor value
1.
There are three different cases that can cause a problem.
●
The pressure sensor value is below a limit, which may vary depending on the volume of the
supply. Probably there is an air bubble inside the cartridge connector tube column. Prepare
the syringe again. Press
OK
and continue with step 2.
●
The ink volume of the cartridge is too low to register on the pressure sensor. To ensure there
are no air bubbles in the tube, you are recommended to purge again. Press BACK and
continue with step 2. If you think there are no air bubbles, press
OK
and continue the process
of purging the ISM tubes from where you were.
42
Chapter 7
Purge the ink system
ENWW