HP Scitex LX600 HP Designjet L65500 Printer and HP Scitex LX Printer Family - - Page 71
On the right side, replace the four T30 screws that secure the rear cover., starting at the top.
View all HP Scitex LX600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
NOTE: The covers are wrapped in plastic, and the screws are inside the packaging. It is recommended to install the covers last, in case of any issue that may require you to remove the covers. It is recommended to wear gloves when removing the covers. 1. On the left side, replace the six T30 screws that secure each cover. The position of the screws is the same on the rear cover as it is on the front cover. 2. On the right side, replace the four T30 screws that secure the rear cover. 3. On the right side, replace the four T30 screws that secure the sliding door, starting at the top. ENWW Install the covers 67
NOTE:
The covers are wrapped in plastic, and the screws are inside the packaging. It is recommended
to install the covers last, in case of any issue that may require you to remove the covers. It is
recommended to wear gloves when removing the covers.
1.
On the left side, replace the six T30 screws that secure each cover. The position of the screws is
the same on the rear cover as it is on the front cover.
2.
On the right side, replace the four T30 screws that secure the rear cover.
3.
On the right side, replace the four T30 screws that secure the sliding door, starting at the top.
ENWW
Install the covers
67