Icom ID-52A Advanced Manual english - Page 168
VFO Scan, Scan Type, Information, Program Skip
View all Icom ID-52A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
10 SCAN OPERATION VFO Scan 1. Push [VFO/MHz] to enter the VFO mode. 2. Push [MODE] to select the operating mode. 3. Hold down [SCAN] for 1 second. •• Opens the Scan Type Select window. 4. Select a scan type. Blinks •• The scan starts. •• The decimal point and the selected Scan Type icon blink. LLWhen receiving a signal, the S-meter displays the received signal strength. 5. Hold down [SCAN] for 1 second. •• Cancels the scan. LLPushing [CLR] also cancels the scan. DDScan Type •• ALL: Full scan •• BAND: Band scan •• DUP: Duplex scan (Displayed only when Duplex is set) •• P-LINK0 ~ 9: Program Link scan •• P00 ~ 24: Program scan •• TONE: Tone scan (For the Tone Squelch scanning) LLInformation •• The frequencies that are set as a Skip channel (PSKIP) are skipped during a scan. (p. 10-6) •• When "Program Skip" is set to "OFF," the Skip channel frequencies are not skipped. (p. 12-5) ([MENU] > SET > Scan > Program Skip) •• To set a Program Link scan, see page 10-8. •• To set a Program scan, see page 10-7. TIP: •• During a scan, rotate [DIAL] to change the scanning direction. •• During a scan, push [MODE] to select the operating mode. •• During a scan, hold down [ ] to turn the Lock function ON or OFF. •• The scan continuously runs, even if you push [MENU] or [QUICK] during a scan. •• You can select a scan type by rotating [DIAL] while holding down [SCAN]. Release [SCAN] to start the scan. 10-5