Icom ID-52A Advanced Manual english - Page 233
Using the Band Scope function, Using the Waterfall display, SCOPE, Band Scope screen operation
View all Icom ID-52A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
15 OTHER FUNCTIONS Band Scope function NOTE: During the continuous sweep, the noise may occur if you bring your hand or body close to the screen. DDUsing the Band Scope function [MENU] > SCOPE 1. Push [MENU]. 2. Select "SCOPE." •• Returns to the standby screen, and starts the continuous sweep. 3. Push [QUICK]. 4. Select "Scope Mode." DDUsing the Waterfall display On the single band display, you can turn the waterfall display ON or OFF. Waterfall zone Scale When selecting a Band Scope zone (with a line in orange) Scale LLInformation •• Higher signal levels are Red, Yellow, Green, Light-blue, Blue, and Black (no signal), in that order. •• During a sweep, the scales on both sides of the waterfall zone are moved with the waterfall. While stopping a sweep, the scales and the waterfall also freeze. •• You can select the Waterfall speed. ([MENU] > SET > Scope > Waterfall Speed) 5. Select the Band Scope display mode. •• Displays the selected display mode, and starts the continuous sweep. 6. Push [ENT]. •• Stops the sweep. LLPush [ENT] again, to resume the sweep for the Continuous Sweep function. 7. When the sweeping stops, rotate [DIAL] to move the sweep marker to a detected signal. •• You can hear the signal audio. LLWhile the sweep is paused, push [CLR] to turn OFF the Band Scope function. Band Scope screen operation Key Action [DIAL] Rotate to select an operating frequency. D-pad() Push to cancel the Band Scope zone selection. D-pad() Push to select the Band Scope zone (with a line in orange). [ENT] Push to start or stop a sweep. [QUICK] Push to open the Quick Menu window. LLWhen selecting the Band Scope zone, only the Band Scope menu is displayed. [CLR] When selecting the Band Scope zone: •• Push to stop the sweep during a sweep. •• Push to turn OFF the Band Scope function while stopping a sweep. TIP: •• If the tuning step is set too wide, the signals in the sweep range may not be displayed (they may be skipped), even if they are strong signals. Therefore, we recommend that you set the tuning step to 20 kHz or less to use the Band Scope function. See the Basic manual Section 3 for details on how to set the tuning step. •• On the AIR band, you cannot hear the displayed frequency's audio during a sweep. When "AF Output (DUAL/AIR Band)" is set to ON, the received audio is momentarily output during a sweep, and you will know that a signal is received without looking at the display. - You can turn "AF Output (DUAL/AIR Band)" ON or OFF on the MENU screen. (p. 12-30) - T he FM Radio audio output may be interrupted due to the AF Output (DUAL/AIR Band) function. In that case, set "AF Output (DUAL/AIR Band)" to OFF, or set "Auto Mute" to OFF. ([MENU] > SET > Scope > AF Output (DUAL/AIR Band)) ([MENU] > FM RADIO > FM Radio Set > Auto Mute) 15-3