JVC GY-DV300U 108 pg. instruction manual on the GY-DV300U Pro-DV Camcorder (PD - Page 35

Battery Pack Operation Cont'd

Page 35 highlights

Battery Pack Operation (Cont'd) Remaining Battery Power Indication TALLY lamp The remaining battery power condition can be checked by the remaining battery power indication on the LCD screen and the TALLY lamp. The battery condition is indicated as shown in the table below. Prepare for battery pack replacement in accordance with the indications. LCD screen Indication LCD Screen Tally Lamp - Remaining battery power indication Remaining Battery Power Remaining battery power is low. Prepare or replace with a fully charged battery pack. Fully charged After the remaining battery power indication starts blinking, recording can be continued for approx. 5 minutes. Operating Time with Battery Pack Slow blinking (1 blink per second) Blinking No remaining battery power. Immediately replace with a fully charged battery pack. After the no remaining battery power warning appears, the GY-DV300 automatically stops operation if the battery power operation is continued. Battery Pack Continuous Operating Time (25°C) GY-DV300 only When KA-DV300 in use BN-V428 Approx. 120 min. Approx. 80 min. PRECAUTIONS FOR THE BATTERY PACK When a fully charged battery pack is attached, the approximate continuous operating time is as shown in the table on the left. ● Battery operating time may differ depending on the number of times the battery has been charged, charging conditions and the operating environment, etc. Regard the values in the table on the left as approximate reference times. ● Operating time is reduced in areas with a cold environment. ● Operating time is reduced when the power zoom lens is used frequently and when start/stop of recording is performed frequently. ● When the battery pack is not in use, it must be stored in a cool, dry place. Do not leave the battery pack in a place where it might be subject to high temperatures (under direct sunlight in a car, etc.), as this could cause battery leakage or shorten the service life. ● When the terminal section of the battery pack gets dirty, the operating time will be shortened. ● If the operating time becomes greatly reduced even immediately after recharging, the service life of the battery pack is nearly finished. Purchase a new battery pack. Recharging ● Recharge the battery pack after completely discharging it. Repeated recharging with residual charge remaining could result in reduced battery capacity. ● If the battery capacity is reduced by repeating incomplete recharging, or recharging without discharging, once discharge the battery pack completely, then recharge it to restore the battery capacity. ● If the battery pack is recharged with its internal temperature raised immediately after use, recharging may not be performed completely. 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108

35
Battery Pack Operation (Cont’d)
Remaining Battery Power Indication
Fully
charged
TALLY lamp
LCD screen
Remaining battery
power indication
The remaining battery power condition can be
checked by the remaining battery power indication
on the LCD screen and the TALLY lamp.
The battery condition is indicated as shown in the table
below. Prepare for battery pack replacement in
accordance with the indications.
Indication
LCD Screen
Tally Lamp
After the no remaining battery power warning appears,
the GY-DV300 automatically stops operation if the
battery power operation is continued.
Remaining battery
power is low.
Prepare or replace
with a fully charged
battery pack.
Blinking
No remaining bat-
tery power.
Immediately replace
with a fully charged
battery pack.
Slow blinking
(1 blink per
second)
Operating Time with Battery Pack
When a fully charged battery pack is attached, the
approximate continuous operating time is as shown
in the table on the left.
Battery operating time may differ depending on the
number of times the battery has been charged,
charging conditions and the operating environment,
etc. Regard the values in the table on the left as
approximate reference times.
Operating time is reduced in areas with a cold
environment.
Operating time is reduced when the power zoom
lens is used frequently and when start/stop of
recording is performed frequently.
Battery
Continuous Operating Time (25
°
C)
Pack
When KA-DV300
GY-DV300 only
in use
BN-V428
Approx. 120 min.
Approx. 80 min.
PRECAUTIONS FOR THE BATTERY
PACK
When the battery pack is not in use, it must be
stored in a cool, dry place.
Do not leave the battery pack in a place where
it might be subject to high temperatures (under
direct sunlight in a car, etc.), as this could cause
battery leakage or shorten the service life.
When the terminal section of the battery pack
gets dirty, the operating time will be shortened.
If the operating time becomes greatly reduced
even immediately after recharging, the service
life of the battery pack is nearly finished.
Purchase a new battery pack.
Recharging
Recharge the battery pack after completely
discharging it. Repeated recharging with residual
charge remaining could result in reduced battery
capacity.
If the battery capacity is reduced by repeating
incomplete recharging, or recharging without
discharging, once discharge the battery pack
completely, then recharge it to restore the battery
capacity.
If the battery pack is recharged with its internal
temperature raised immediately after use,
recharging may not be performed completely.
Remaining
Battery Power
After the remaining battery power indication
starts blinking, recording can be continued for
approx. 5 minutes.