Kyocera Ai5555 NC-2 Instruction Hand Book - Page 163
Factory Default Jumper - JP10
View all Kyocera Ai5555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Jumper Settings Changing Jumper Settings Factory Default Jumper - JP10 The Reset to Factory Default JP10 jumper block allows you to force the NC-2 back to factory default settings. When you change this jumper, the parameters altered by any administrative programs will be restored to factory default values, losing any special configuration information that may have been entered. The NC-2 is shipped with the jumper set to NORM for normal customer configuration. To restore the NC-2 factory default setting, you must change the jumper to FACT (for factory default), power up the NC-2, power down the NC-2, and then change the jumper back to NORM. See the following illustration. NC-2 Board Illustration JP10 o-o o NORM FACT MAN AUTO 10BT THIN o o-o o-o o JP4 JP3 JP5 o o-o RXA TXA BNC Connector A-10