Kyocera Ai5555 NC-2 Instruction Hand Book - Page 96
Assigning IP Address with ARP
View all Kyocera Ai5555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
UNIX Printing Through TCP/IP Windows for Workgroups Assigning IP Address with ARP Use the following procedure to use ARP to configure the IP address. 1. From Windows, enter the MS/DOS box. 2. At the command prompt enter: (a) ping [any valid IP address on your network - not the print server]. The identified unit should reply. If you do not ping the network, the arp cache will be empty (no static entries), and you will receive an error 2 message (after performing the next step). (b) arp -s [IP address of the NC-2 Print Server] [MAC Address of the NC-2 Print Server] The entry should be accepted. You will receive an error 3 message if our Remote Access Software (RAS) is installed. (c) ping [IP address of the NC-2 Print Server]. The request should time out. 3. Recycle the power on the print server. The NC-2 Print Server will produce a status page that should include the entered IP address. 4. When the NC-2 Print Server is up again, type the following at the command prompt: (a) ping [IP address of the NC-2 Print Server] Continue until you get a reply. NOTE: This only enters the IP address. You must use the Network Management Utility to enter the other IP parameters. 5-6 UNIX Printing Through TCP/IP