Kyocera Ai5555 NC-2 Instruction Hand Book - Page 38
Enable NetWare, Print Server Name, Print Server Password, Password Retype
View all Kyocera Ai5555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
NetWare Configuration Using the Network Management Utility Using Help Screens Protocols Setup NetWare The following information explains how you can change each field or make entries on the NetWare Configuration Menu. Enable NetWare When checked, Novell NetWare is enabled as a protocol for the print server. If Novell NetWare is a permanent protocol, then the box cannot be unchecked. For print servers where Novell NetWare is not the primary protocol, click this box to either enable or disable the protocol. Print Server Name Each Novell print server has a unique name assigned to it. The print server uses the default name of NC2_(serial_number). The serial number is located on a label attached to the NC-2 board. If you want to change the default name or the existing name, enter the new print server name in this field. The name can be up to 63 characters in length. You must also remember to change the name in PCONSOLE; otherwise the name change will not take effect. Print Server Password The network administrator assigns a password to the Novell print server. When a password is assigned through NetWare's PCONSOLE, you need to inform the print server of the assigned password. When you enter the password in this field, make sure it is the same password that was assigned through PCONSOLE. The password is stored in the print server configuration memory. To assign a password to the print server in PCONSOLE, refer to your Novell documentation. Using this program, first type in the password in the Print Server Password field, then retype the password in the Password Retype field. The password is the same for all file servers assigned to the print server. Password Retype See above. NetWare Configuration 3-17