Kyocera KM-3050 3050/4050/5050 Operation Guide Rev-3 (Advanced) - Page 232
Network Setup, TCP/IP Setup (by Entering IP Addresses)
View all Kyocera KM-3050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
System Menu Network Setup The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP, IPX/SPX, NetBEUI, and AppleTalk. It enables network printing on the Windows, Macintosh, UNIX, NetWare and other platforms. TCP/IP Setup (by Entering IP Addresses) Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway addresses. NOTE: Prior to the IP address entries, obtain permission from the network administrator. Use the procedure below to specify the TCP/IP settings. 1 Press the System Menu key. 2 Press [System], [Next] of Network and then [Change] of TCP/IP. 3 Press [On] on the left side of the touch panel. System - TCP/IP Use TCP/IP. Off DHCP On On Off Status 4 Press [Off] of DHCP. IP Address Subnet Mask Default Gateway 0.0.0.0 0.0.0.0 0.0.0.0 Cancel OK 10/5/2006 10:10 5 Press [IP Address] and enter the address using the numeric keys. System - TCP/IP Use TCP/IP. Off DHCP On On Off IP Address Subnet Mask Default Gateway 192.168.1.150 0.0.0.0 0.0.0.0 Status Cancel OK 10/5/2006 10:10 6 Press [Subnet Mask] and enter the address using the numeric keys. 6-56 ADVANCED OPERATION GUIDE