Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 147
Fig. 1-92
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
(7) Suspend the indoor unit as follows. (a) Mount a washer and two hexagonal nuts on each suspension bolt as shown in Fig. 1-92. (b) Lift the indoor unit with a lifting machine to the ceiling surface, and place it on the washers through the notches, to fix it in place. (Fig. 1-93) (c) Tighten the two hexagonal nuts on each suspension bolt to suspend the indoor unit as shown in Fig. 1-94. NOTE A ceiling surface is not always level. Please confirm that the indoor unit is evenly suspended. For the installation to be correct, leave a clearance of about 3/8" between the ceiling panel and the ceiling surface and fill the gap with an appropriate insulation or filler material. (8) If the tubing and wiring are to go towards the rear of the unit, make holes in the wall. (Fig. 1-95) (9) Measure the thickness of the wall from the inside to the outside and cut PVC pipe at a slight angle to fit. Insert the PVC pipe in the wall. (Fig. 1-96) 1. Specifications Approx. 1 inch Ceiling surface Washer (supplied) Suspension bolt Nut (field supply) Fig. 1-92 1 Fig. 1-93 Fig. 1-94 Indoor side Outdoor side Fig. 1-95 PVC pipe (field supply) INSIDE Wall Cut at slight angle Fig. 1-96 OUTSIDE PVC pipe Slight angle 1-139