Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 152
Checking the Drainage, To mount the tube cover, use 5/16
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
CAUTION Do not install an air bleeder tube as this may cause water to spray from the drain pipe outlet. (Fig. 1-110) If it is necessary to increase the height of the drain pipe, the section directly after the connection port can be raised a maximum of 19-11/16". Do not raise it any higher than 19-11/16", as this could result in water leaks. (Fig. 1-111) Do not install the pipe with an upward gradient from the connection port. This will cause the drain water to flow backward and leak when the unit is not operating. (Fig. 1-112) Do not apply force to the piping on the unit side when connecting the drain pipe. The pipe should not be allowed to hang unsupported from its connection 1 to the unit. Fasten the pipe to a wall, frame, or other support as close to the unit as possible. (Fig. 1-113) Refer to " SUPPLEMENT ON DRAIN PIPING". 6-29. Checking the Drainage After wiring and drain piping are completed, use the following procedure to check that the water will drain smoothly. For this, prepare a bucket and wiping cloth to catch and wipe up spilled water. (1) Connect power to the power terminal board (L1, L2 terminal) inside the electrical component box. (2) Remove the tube cover and through the opening, slowly pour about 0.3 gal. of water into the drain pan to check drainage. (3) Short the check pin (CN5 white) on the indoor control board and operate the drain pump. Check the water flow through the transparent drain port and see if there is any leakage. CAUTION Be careful since the fan will start when you short the pin on the indoor control board. (4) When the check of drainage is complete, open the check pin (CN5 white) and remount the insulator and drain cap onto the drain inspection port. CAUTION To mount the tube cover, use 5/16" (4 × 8 mm) tapping screws. Do not use long screws as they may puncture the drain pan and cause water leakage. 1-144 Air bleeder 1. Specifications Not good Fig. 1-110 Good 11-13/16" or less 19-11/16" or less Fig. 1-111 Not good Upward gradient Fig. 1-112 Support pieces Good Fig. 1-113