Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 169

1. Specifications When the flap position is set to 4 or 5 and the unit is in the cooling or dry mode, the flap position is moved to 3 and the operation is started. (refer to Fig. 1-143) If you wish to change the selected indoor unit, follow the step 2. Stop the system before performing these steps. NOTE The flap swings during the operation under "Setting the Flap Separately". At this time, the unselected flaps are moved to the position 1 . (refer to Fig. 1-143) 1 Press and hold the , and buttons simultaneously for 4 seconds or longer. 2 If group control is in effect, press the button to set. At this time, the fan at the indoor unit begins and select the address (unit No.) of the indoor unit operating. 3 Designate the item code " " by adjusting the Temperature Setting / buttons. 5 Press the button. (The display stops blinking and remains lit, and setting is completed.) If you wish to change the selected indoor unit, follow the step 2. 6 Press the display. button to return to normal remote controller Electrical component box =90 1 ˃ ˃ =91 =93 " 4 Press the timer time setting data. =92 / buttons to select the desired Flap position 1 2 3 54 Fig. 1-143 * Setting data " " (refer to Fig. 1-143) Setting data Flap position during operation Without separate setting Swing Move to position 1 and stay Move to position 2 and stay Move to position 3 and stay Move to position 4 and stay Move to position 5 and stay 1-161