Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 176
Left-side tubing, Switching drain hose and drain cap, Drain hose, Drain cap, Fig. 1-171
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
6-53. Left-side tubing (1) Lead the tubing and drain hose through the wall, allowing sufficient length for connection. Then bend the tubing using a tube bender to make the attachment. (Fig. 1-171) (2) Switch the drain hose and drain cap. Switching drain hose and drain cap (a) Locate the drain hose and the drain cap. (Fig. 1-172) (b) Remove the screw fastening the drain hose on the right side, and pull out the drain hose to remove it. (Fig. 1-172) (c) Apply moderate force to pull off the drain cap on the left side. (If you cannot pull it off by hand, use a long-nose pliers.) (d) Reattach the drain hose to the left side and the drain cap to the right side. (Fig. 1-173) Drain hose Slide the drain hose fully onto the drain pan outlet. (It will be easy to slide when water is added.) Check that the screw holes in the drain bracket and the drain pan outlet are aligned and securely in contact, then fasten them with the screw. (After attaching the drain hose, check that it is 1 attached securely.) (Fig. 1-174) Drain cap Use a Phillips head screwdriver to push the drain cap in firmly. (If it is difficult to push in, wet the cap with water first.) (3) Install the indoor unit on the rear panel. (4) Connect the tubing and wiring led inside from outdoors. (5) After completing a leak test, bundle the tubing together with armoring tape and store it inside the tubing storage area at the back of the indoor unit and hold it with clamps. (Figs. 1-173 and 1-175) 1. Specifications Hole in wall Rear panel Bent part Narrow tube Wide tube Fig. 1-171 Drain hose Clamp Drain cap Fig. 1-172 Clamp Drain cap Drain hose Fig. 1-173 Screw hole Drain pan outlet Drain bracket Drain hose Screw Drain hose Drain bracket Screw Fig. 1-174 1-168 Conduit Refrigerant tubing Inter-unit wiring Fig. 1-175