Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 167
<Procedure of CZ-RTC2>, Stop the system before performing these steps., Fig. 1-141
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
(4) Setting the Flap Separately 1) The 4-air outlet flap can be adjusted separately during operation. When not adjusted separately, all flaps operate in the same manner. Air discharge port Flap (adjustment for up-down airflow direction) Stop the system before performing these steps. 1 Press and hold the , and buttons simultaneously for 4 seconds or longer. 2 If group control is in effect, press the button and select the address (unit No.) of the indoor unit to set. At this time, the fan at the indoor unit begins operating. 3 " ", unit No. " " (or " " in the case of group control), item code " ", and settings data " " are displayed blinking on the remote controller LCD display. 4 Designate the item code " " by adjusting the Temperature Setting / buttons. Electrical component box =90 =91 =93 =92 1. Specifications 5 Press the timer time / buttons to select the desired setting data. Flap position 54 1 2 3 Fig. 1-141 * Setting data " " (refer to Fig. 1-141) Setting data Flap position during operation Without separate setting Swing Move to position 1 and stay Move to position 2 and stay Move to position 3 and stay Move to position 4 and stay Move to position 5 and stay 1 When the flap position is set to 4 or 5 and the unit is in the cooling or dry mode, the flap position is moved to 3 and the operation is started. (refer to Fig. 1-141) NOTE The flap swings during the operation under "Setting the Flap Separately". At this time, the unselected flaps are moved to the position 1 . (refer to Fig. 1-141) 6 Press the button. (The display stops blinking and remains lit, and setting is completed.) If you wish to change the selected indoor unit, follow the step 2. 7 Press the button to return to normal remote controller display. 3 2 7 4 1-159 1 6 5