Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 274
Fig. 3, All units start/stop Fig. 3, Cooling/heating change Fig. 3, All units test run Fig. 4
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
l All units start/stop (Fig. 3) 5. Outdoor unit maintenance remote control The (Start/Stop operation) button can be used to start and stop all the indoor units. • The LED illuminates if any indoor units is operating. LED • The LED blinks if an alarm at any of the operating indoor units occurs. l Cooling/heating change (Fig. 3) " NOTE Cooling and heating mode changes are only available when all indoor units are stopped. The " (Mode) button can be used to change between heating and cooling operation. • The display indicates the operating mode of the indoor unit with the lowest unit No. l All units test run (Fig. 4) The (Check) button can be used to start and stop a test run for all indoor units. • Press and hold for 4 seconds to turn ON. During the test run " " is displayed. • The status of test runs performed from the indoor unit remote controller is not displayed on the outdoor unit maintenance remote controller. Fig. 3 " l Double-speed • Do not use for actual operation. (Doing so may damage the devices.) The timer button can be used to change between double-speed and normal operation. • During double-speed operation, the Sleeping Mode mark is displayed. 5 Fig. 4 " Fig. 5 5-14