Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 190

CZ-RWSU3U 7-12. Supplied Accessories Wireless Remote Remote Control Controller Holder (1) (1) Supplied Accessories AAA Size Battery (2) Operating Instructions (1) Wood Screw (2) Clamper (1) 1. Specifications 7-13. Installing the Receiver The receiver can only be installed on the corner indicated in Fig. 1-219. Consider how the panel will face when it is installed on the indoor unit. 1 Remove the air inlet grill. 2 Remove the screw holding the adjustable corner cover. Then slide the cover to the side and remove it. (Fig. 1-220) Receiver position Adjustable corner cover Ceiling panel 1 Box with indoor unit's electrical parts Fig. 1-219 Screw Fig. 1-220 Adjustable corner cover 3 To pass the wire through the panel, bend the part (shaded area) on the square hole and then pass wire protrudingfrom the wireless receiver through the grill. (Fig. 1-221) 4 After wiring according to the directions in "Wiringfor the Receiver", leave enough wire length so that the receiver's adjustable corner cover can be removed andfasten the wire with the clamper. (Fig. 1-221) 5 Hang the corner cover string on the pin of the ceiling panel (Fig. 1-222). Then slide the corner cover onto the ceiling panel until the three clips are correctly located, and then fix it in place with the screws. Make sure the wire is not caught. Refer to the installation instructions supplied with the panel. Bend the part (shaded area) with a screwdriver or similar implement to allow the wire to pass through. Fix it in place with the clamper. Pin. Fix the screw. Fig. 1-221 Fig. 1-222 Make sure the three clips on the corner cover are located over the holes on the ceiling panel and fix it in place with the supplied screws. For more information about wiring and test operation, see the sections on "Wiring for the Receiver" and "Test Operation" 1-182