Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 294
CZ-RTC3 / CZ-RTC5, <Procedure of CZ-RTC3 / CZ-RTC5>
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 294 highlights
1. Keep pressing the , and buttons simultaneously for 4 or more seconds. The "Maintenance func" screen appears on the LCD display. 2. Press the or button to see each menu. If you wish to see the next screen instantly, press the or button. Select "9. Auto address" on the LCD display and press the button. Maintenance func 20:30 (THU) 9. Auto address 10. Set elec. consumption 11. Set touch key 12. Check touch key Sel. Page [ ] Confirm 3. The "Auto address" screen appears on the LCD Auto address display. Code no. 20:30 (THU) O/D unit no. Change the "Code no." to "A1" by pressing the A1 1 or button. Sel. Next 6. Test run 20:30 (THU) [ ] START CZ-RTC3 / CZ-RTC5 4. Select the "O/D unit no." by pressing the or button. Select one of the "O/D unit no." for automatic address by pressing the or button. Then press the button. Approximately about 10 minutes are required. When automatic address setting is completed, the units return to normal stopped status. 1 Press the remote controller timer time button at the same time. button and (Press and hold for 4 seconds or longer.) 2 Next, press either the temperature setting / button. (Check that the item code is "A1".) 3 Use either the button to set the system No. to perform automatic address setting. 4 Then press the button. (Automatic address setting for one refrigerant system begins.) (When automatic address setting for one 2 system is completed, the system returns to normal stopped status.) (During automatic address setting, " " is displayed on the remote controller. This message disappears when automatic address setting is completed.) 5 Repeat the same steps to perform automatic address setting for each successive system. 14 4 3 CZ-RTC4 6 6-10