Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 197
Swing/Wind Direction button, Mode Select button
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
7-23. Misoperation Alarm Indicators A blinking lamp for other than the signal receiving unit filter shows that a problem has occurred in the unit, so make an inspection. (Refer to servicing information in the service manual, etc.) Also, if wired remote controller and dedicated service check lines (CV6380230938: service use) are available, then detailed error information can be obtained by connecting to the service connector as shown in the drawing. For information on how to connect to the signal receiving unit, refer to the instruction manual that came with the dedicated service check lines. 1. Operation Display Service connector 1. Specifications ALL• RCU : SUB PCB CHK. TEST RUN RCU : MAIN NORMAL Fig. 1-238 8. Transmitter 9. Remote control sensor 1 2. Start/Stop button 3. Fan speed button 4. Swing/Wind Direction button 5. Timer setting buttons 6. Reset button 7. Cover 10. Temperature setting buttons 11. Filter button 12. Mode Select button 13. Ventilation button 14. Address button 15. Sensor button 16. Clock button Fig. 1-239 Table 1-16 OPERATION lamp Lamp TIMER lamp STANDBY lamp Bright Alternately Alternately Concurrent Concurrent Cause of Trouble No power supply or mis-wiring of signal receiving unit. S.C.* errors between the indoor unit's controller (PCB) and signal receiving unit. S.C. errors between indoor and outdoor units. Indoor unit protector is activated. Outdoor unit protector is activated. Compressor protector is activated. Mis-setting of indoor unit. Mis-setting of outdoor unit. * S.C.: Serial communications 1-189