Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 281
Setting Modes : Setting the Outdoor Unit EEPROM, Setting mode 1, Display of fi, rst 3 digits
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 281 highlights
6. Mode Settings 5-12. Setting Modes : Setting the Outdoor Unit EEPROM Setting mode 1 À Press and hold the (Check) button and (Ventilation) button simultaneously for 4 seconds or longer. Á Press the temperature setting and buttons to change the item code. The item codes and setting data are shown in the table below.  Press the timer time and change the setting data. buttons to To confirm the changed setting data, press the button. (At this time, " and remains lit.) " display stops blinking à During this mode, " " is displayed, blinking. The outdoor unit address display section displays "ALL," the item code and number (DN value in the table), and the setting data (6 digits). (The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig. A ) and the last 3 digits (Fig. B ). When the first 3 digits are displayed, the bottom dot of the colon is illuminated.) Ä To exit the setting mode, press the button. (Check) 2WAY SYSTEM Outdoor Unit Maintenance Remote Controller 5. Outdoor unit maintenance remote control A Display of first 3 digits Á " ÂÄÀ B Display of last 3 digits Á " ÂÄÀ A and B are displayed alternately. (Example shows display of 000 001.) 5 5-21