Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 187
Ceiling Type T1, 8. Operating Controller Installation
View all Panasonic 26PEK2U6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
Ceiling (Type T1) 7-7. Indicator Section Installation Remove the side panel to install the indicator section. (Fig. 1-214) (1) Remove the side panel. Open the air intake grille, remove the screw at one place and then remove the side panel by sliding it toward the front (arrow direction). (2) Remove cover A and cover B. Insert a flathead screwdriver into the grooves of cover A to remove cover A and cover B. (When removing the cover, take care not to scratch the panel.) (3) Remove cover B from cover A. (4) Install the indicator section at cover A. (5) After passing through the lead wires, install cover A and the indicator section at the panel hole. (The protrusion part of cover A is fixed with the panel hole.) (6) Bundle the lead wires along with the wiring of the louver motor. (7) Install the side panel. 7-8. Operating Controller Installation CAUTION Do not twist the operating controller wires together with the power supply wires. Doing so can result in malfunction. If electrical noise is induced in the unit power supply, take appropriate measures, for example installing a noise filter. 1. Specifications Indicator section Indicator section Cover B (Not used when the indicator section is installed.) Panel Side panel Grooves Cover A Air intake grille Cover A Grooves Fig. 1-214 1 Install the operating controller on the top face of the air intake section (space between the fan motor and the electrical component box). (Fig. 1-215) (1) Fasten the operating controller to the ceiling panel of the air intake section with the 2 supplied screws (4×L13/32"). (2) Draw the lead wires into the electrical component box and connect the operating controller 2 wires (WHT, BLK) to the remote control wires in the electrical component box. (3) Connect the indicator section and the operating controller using the 6P connector in the electrical component box. Operating controller Electrical component box Fig. 1-215 1-179