Panasonic 26PEK2U6 26PEK2U6 Service Manual - Page 192

CZ-RWST2U 7-17. Supplied Accessories Wireless Remote Remote Control Controller Holder (1) (1) Supplied Accessories AAA Size Battery (2) Operating Instructions (1) Wood Screw (2) Clamper (1) 1. Specifications 7-18. Installing the Receiver 1 Open the air inlet grill on the side panel. Remove the 1 screw and move it toward the front (in the direction of an arrow) to remove it. (Fig. 1-223) 2 Wrap the tip of a slotted screwdriver with plastic tape and then insert it under the O-marked surface of the cover, wiggling the cover free. (Fig. 1-224) (Be careful not to scratch the panel.) 3 After passing the lead wire through the panel, install the receiver in the hole in the panel. 1 (The projecting parts of the receiver is held in the hole in the panel.) 4 Fasten the receiver's lead wire to the cable clip that is holding the wire from the louver motor. (Fig. 1-225) 5 Attach the side panel. 6 Put the receiver's lead wire together with other wires such as the louver motor wire, and fasten them with the cable clip. (Fig. 1-226) Use the hole in the upper part of the wiring box to lead it in. For more information about wiring and test runs, see the sections on "Wiringfor the Receiver" and "Test Operation" Slotted screwdriver (Wrapped with plastic tape) Side panel Panel Fig. 1-223 Air inlet grill Cable clip Plastic tape Insert it under the O-marked surface of the cover. Cover Fig. 1-224 Cable clip Receiver Fig. 1-225 1-184 Panel Fig. 1-226