Panasonic AG-DVX200 Operating Instructions - Volume 2 - Page 53

Using Focus Transition ≥ Select the [FOCUS TRANSITION] menu. (l 52) ≥ Register [FOCUS TRANS] to a USER button. (l 74) 1 Switch to Manual Focus Mode. (l 44) 2 Press the USER button to which [FOCUS TRANSITION] is registered or touch the applicable USER button icon. 3 Touch a registered item ([1]s[3]). ≥ Focus Transition will start. Focus will shift slowly from the current position to the registered position. This will take a few seconds. (l 54) ≥ As the focus shifts, the Focus Transition bar will move MF50 S E from [S] to [E]. 4 Touch [EXIT] to exit Focus Transition. 1 2 3   A [EXIT] B Focus Transition bar ≥ If you move this unit a lot after setting the focus position, focus may not stop at the set position. ≥ When Focus Transition is in use, focus cannot be adjusted with the focus ring. ≥ Focus Transition is not available in the following cases: j When Auto Focus is used j During Freeze Frame (l 81) j In Variable Frame Rate Mode (l 91) j When color bars are displayed. (l 95) j When a remote control (commercially-available) is connected (l 113) ≥ Focus Transition settings are canceled in the following cases. To use Focus Transition again, register a focus position again. (l 52) j If you operate the zoom j If you enable or disable Infrared Recording Mode ≥ You can only use the following USER button functions by pressing one of the USER buttons 5s8 when Focus Transition is in use (l 74): j [FOCUS ASSIST] j [FOCUS TRANSITION] j [INFRARED REC] j [BACKGROUND] j [PRE-REC] j [EVF ON/OFF] j [AUTO REC] j [MENU] - 53 -