Yamaha CL3 Owner's Manual - Page 54
When you recall a scene, it takes a certain amount, of time for the faders to stop.
View all Yamaha CL3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Troubleshooting There is insufficient headroom, especially when EQ boost is applied. ❍ Use the EQ attenuator function to lower the level. An input signal is being input, but there is no monitor output. ❍ Could the DIMMER be applied? ❍ Could the MONITOR CH be assigned even though its output port has not been connected to an external device? Signal is delayed. ❍ Check whether the delay setting for each input channel and OUTPORT is set correctly. Rotating a MIX knob does not change the send level to the MIX bus. ❍ Is the TO MIX SEND ON/OFF button turned on? ❍ Is the MIX [ON] key turned on? ❍ Is the MIX bus set to VARI type? ❍ Could the fader have been lowered if the send point is set to POST? Cannot save scene memory or various library data. ❍ Are you attempting to save the data to a read-only scene/library or a protected scene? ❍ Could user level restrictions have been specified? Cannot save to a USB flash drive. ❍ Could the USB flash drive be protected? ❍ Does the USB flash drive have enough free capacity to save the data? ❍ When formatting the USB flash drive, format it in FAT32 or FAT16 format. ❍ Could the recorder be playing? Cannot transmit or receive MIDI data. ❍ Is the MIDI PORT selected correctly? ❍ Are the transmission and reception modes and chan- nels selected correctly? ❍ Has an event corresponding to the particular Program Change message been specified? When you recall a scene, some channels/parameters are not updated. ❍ Could that channel or parameter be set to Recall Safe? ❍ Could Focus be set in such a way that the channels or parameters will not be updated? ❍ Could user level restrictions have been specified? You turn on a CUE button in the EFFECT screen, but it is automatically defeated. ❍ This is defeated automatically when you switch screens in the display. When you recall a scene, it takes a certain amount of time for the faders to stop. ❍ Could you have specified a fade time? The panel LEDs or LCD display are too dark / too bright. ❍ This can be adjusted in the SETUP screen. Signal level of a specific frequency is low. ❍ Could the EQ gain be turned down excessively? ❍ Routing a signal through a GEQ or effect will delay it relative to other signals. If this signal is mixed with another signal that is routed via a different signal path, a comb filtering effect will cause the level of a specific frequency to be decreased. Cannot control an I/O rack. ❍ Are the rotary switch and DIP switches on the I/O racks set correctly? ❍ Does the channel being controlled match the channel on the I/O rack? Cannot control the CL unit from CL Editor. ❍ Is the computer connected to the unit's Network jack correctly? ❍ Is the network setting of the CL unit specified correctly? ❍ For details on settings, refer to the CL Editor installation guide posted on our website. Cannot control the CL unit from CL StageMix. ❍ Is the WiFi setting in CL StageMix set correctly? ❍ Is the unit's Network jack on the CL unit connected to the WiFi access point correctly? ❍ Is the network setting of the CL unit specified cor- rectly? ❍ Refer to the CL StageMix Owner's Manual on our web- site. In the LCD display, there are some black points (unlit) or white points (always lit). ❍ Unfortunately, this is a common characteristic of TFT-LCDs and not a malfunction. 54 Owner's Manual