Adaptec 1966600 User Guide - Page 101
Replacing a RAID Controller, A Controller Status LED goes out, indicating which RAID
UPC - 760884139202
View all Adaptec 1966600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
DuraStor 6220SS/7220SS Installation and User's Guide Replacing a RAID Controller When a RAID controller fails s The alarm sounds. s The Fault LED on the front bezel lights up. s A Controller Status LED goes out, indicating which RAID controller has failed. s The system monitor displays an error event. A failed controller should be replaced immediately. Note: The DuraStor 6200S/7200S external RAID controller is hot-swappable. 1 Remove the front bezel. See Removing the Front Bezel on page 3-3. 2 Identify and locate the failed RAID controller. Controller 1 is on the left and Controller 2 is on the right. 3 Pull out on the two latches that secure the controller canister. 4 Using the latches as handles, carefully pull the controller canister from the RAID appliance. See Figure 5-1. Latches Open Figure 5-1. Removing the Controller 5 Install the replacement controller in the controller canister. Refer to your controller's installation guide and/or the DuraStor 6200S/7200S External RAID Controller Installation Guide for detailed instructions. 5-2