Adaptec 1966600 User Guide - Page 49
Connecting to Three Storage Enclosures (25–36-Drive Configuration)
![]() |
UPC - 760884139202
View all Adaptec 1966600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Installing the DuraStor Storage Subsystem Connecting to Three Storage Enclosures (25-36-Drive Configuration) Note: This configuration is only available when you are using a single controller in your DuraStor SCSI RAID appliance. One of the host channels-Host In (CH 3)-is used as a drive channel, which limits the DuraStor RAID appliance to a single Host In port. 1 Establish the drive configuration by setting the SAF-TE card switches to reflect the settings shown in Figure 3-14. SAF-TE ID = 15 RAID Controllers = 6 & 7 Single-bus Mode DAA SSSDR B 0 1 0 1 2 LM 123 4 5678 UP (1) DOWN (0) Slot 1 ID 1 Slot 2 ID 3 Slot 3 ID 5 Slot 4 ID 2 Slot 5 ID 4 Slot 6 ID 0 Slot 7 ID 9 Slot 8 ID 11 Slot 9 ID 13 Slot 10 ID 10 Slot 11 ID 12 Slot 12 ID 14 Switch Settings Drive IDs of the Drive Slots (Drive Channel Side) Figure 3-14 Single-Bus 25-36-Drive Switch Settings 2 Connect the DuraStor SCSI RAID appliance to the DuraStor 312R using SCSI data cables, as shown in Figure 3-15. 3 Go to Connecting the SCSI RAID Appliance to the Host System on page 3-17, which describes how to set your operating mode. 3-15
![](/manual_guide/products/adaptec-1966600-user-guide-52b377a/49.png)