Adaptec 1966600 User Guide - Page 105
Replacing the DuraStor RAID Appliance Chassis, Replacing the Front Bezel, Powering
UPC - 760884139202
View all Adaptec 1966600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
DuraStor 6220SS/7220SS Installation and User's Guide 4 Pull the power supply from the RAID appliance. See Figure 5-4. Figure 5-4. Removing the PSU 5 Slide the new PSU into the empty bay until it seats completely and the release latch resets. 6 Turn on the replacement PSU. 7 Replace the front bezel. See Replacing the Front Bezel on page 3-6. The Fault LED on the front bezel goes out. Replacing the DuraStor RAID Appliance Chassis Warning: Printed circuit board components are sensitive to electrostatic discharge. To prevent damage, establish a ground for yourself by using a wrist grounding strap, or by touching the metal chassis prior to handling or installing a printed circuit board component. 1 Power off the host computer, the DuraStor 312R storage enclosure, and the defective DuraStor RAID appliance. Note: Refer to the host computer user's guide and Powering Off on page 3-54. Mark or make a note of the location of the data cables prior to disconnecting or removing these items. Tag the cables appropriately to make reinstallation easier. 2 Disconnect the data cables and power cable from the defective DuraStor RAID appliance. 3 Remove the front bezel. See Removing the Front Bezel on page 3-3. 5-6