Autodesk 507B1-90A211-1301 User Guide - Page 190

See also: ■ "Presenter Page" on page 436 Stereo Rendering Stereoscopic viewing in Autodesk Navisworks allows the viewing of the 3D model through stereo-enabled hardware, including active and passive stereo viewing glasses in conjunction with both CRT screens and dedicated projectors. IMPORTANT Using stereo rendering requires the host computer have an OpenGL graphics card with stereo support. Additionally, some drivers require stereo to be explicitly enabled in the driver and may require lower color or resolution settings before the stereo rendering becomes available. When the video output is in stereo mode, the view looks blurred without the correct glasses being worn. If the camera is in orthographic mode, it needs to be set to perspective for the effect to work correctly. NOTE As the view for each eye has to be rendered separately it is not possible to support incremental filling in of detail in stereo mode. The detail appears when rendering is complete. Progress can be seen using the bar in the status area, and it is still possible to interrupt and start interacting again at any time. In focal point-based navigation modes (such as examine, orbit, and turntable) the model is positioned so that parts closer than the focal point appear in front of the screen, with the rest behind. In other navigation modes (such as walk and fly), the focal point is set so that any avatar will be level with the screen. Objects between you and the avatar will appear in front of the screen. You can adjust the out of screen effect in the Stereo Options dialog box. To enable stereo rendering ■ Click View ➤ Stereo. NOTE This option is only available if you have the required hardware, and the correct driver and display settings. To adjust the stereo effects 1 Click View ➤ Stereo Options. 2 In the Stereo Options dialog box, move the Magnitude slider to vary the strength of the effect. 3 To adjust the out of screen effect, select the Enable check box, and then move the slider to control how much of the scene appears out of the screen during navigation. 4 If you need to swap the left and right eyes over, select the Swap Eyes check box. This can be useful when moving from CRT to a large screen projector and back. 5 Click OK. 178 | Chapter 7 Control Model Appearance and Render Quality