Canon EOS C500 Instruction Manual - Page 109
K/2K/MXF Setup], S&F STBY
View all Canon EOS C500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Special Recording Modes Shooting frame rate 109 Playback frame rate 3 Press the START/STOP button to begin recording. • The tally lamp illuminates. • [S&F] changes to [Ü S&F] while recording. 4 Press the START/STOP button again to stop recording. • A clip is recorded at the set frame rate. • [S&F STBY`] (during 4K and 2K modes) or [S&F STBY] (during MXF mode) appears at the top of the screen. • The tally lamp goes out. Setting the Shooting Frame Rate from the Shooting Screen If you set an assignable button to [S&F Frame Rate], you can conveniently set the shooting frame rate from the shooting screen without having to go through the menus. 1 Set an assignable button to [S&F Frame Rate] (A 111). 2 Press the assignable button. • The shooting frame rate will be highlighted in orange. 3 Push the joystick up/down or turn the SELECT dial to select the desired frame rate. 4 Press SET. • The display of the shooting frame rate will return to normal. NOTES • You can use only one special recording mode at a time. In addition, slow & fast motion mode cannot be used with double slot recording. • While recording, you cannot change the shooting frame rate. • For lower shooting frame rates, it may take approximately 1 second to stop recording. • During special recording mode, the time code signal will not be output from the MON. terminals, TIME CODE terminal or HD/SD SDI terminal. During 4K and 2K modes, the time code signal will be output from the 3G-SDI terminals. • Slow & fast motion mode will be deactivated if the special recording mode is changed or turned off. It will be deactivated also if you change the video configuration. • When the bit rate in the [ 4K/2K/MXF Setup] > [MXF] > [Bit Rate/Resolution] setting is set to [50 Mbps 1920x1080] or [50 Mbps 1280x720], relay recording is not available during slow motion recording. • During 4K and 2K modes, the running mode of the time code (A 84) is set to [Free Run] and cannot be changed. During MXF mode, the running mode is set to [Regen.]. The time code advances while video is recorded. If the running mode of the time code is set to [Free Run] or the time code is input from an external source, the running mode will switch to [Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will return to its previous setting.