Canon EOS C500 Instruction Manual - Page 142
Video Output Configuration, 4K/2K/MXF Setup]
View all Canon EOS C500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Video Output Configuration 142 Video configuration for recording HDMI OUT terminal5, 9 SYNC OUT terminal10 System priority Recording mode Resolution RAW 4096×2160 3840×2160 4K HRAW 4096×1080 3840×1080 12-bit 2048×1080 1920×1080 2K 10-bit 10-bit 2048×1080 1920×1080 Frame rate 59.94P 29.97P 23.98P 50.00P 25.00P 24.00P 59.94P 50.00P 59.94P 29.97P 23.98P 50.00P 25.00P 24.00P 59.94P 50.00P HD SD 1080/59.94i 480/59.94P 1080/50.00i 576/50.00P 1080/60.00i 720/59.94P 720/50.00P - 480/59.94P 576/50.00P 1080/59.94i 480/59.94P 1080/50.00i 576/50.00P 1080/60.00i 720/59.94P 720/50.00P - 480/59.94P 576/50.00P HD 1080/59.94i 1080/50.00i 1080/60.00i 720/59.94P 720/50.00P 1080/59.94i 1080/50.00i 1080/60.00i 720/59.94P 720/50.00P SD 480/59.94i 576/50.00i - 480/59.94i 576/50.00i 480/59.94i 576/50.00i - 480/59.94i 576/50.00i 1 The resolution will be set to 1920x1080. When [ 4K/2K/MXF Setup] > [4K (4096/3840)] or [2K (2048/1920)] > [Resolution] is set to [4096x2160], [4096x1080] or [2048x1080], you can select 2048x1080 or 1920x1080 for the output (A 147). 2 The camera can apply onscreen markers, zebra patterns, peaking and magnification to the MON. 1 terminal output. The camera can apply magnification to the MON. 2 terminal output. 3 Depending on the signal, you can switch between the P and PsF setting (A 147, 149) for output. 4 Set [¢ Video Setup] (in mode) or [ 4K/2K/MXF Setup] (in mode) > [HD/SD SDI] > [Output] to [HD], [SD] or [Off]. 5 You can display zebra patterns on an external monitor during HD output (A 83). Zebra patterns will not be output during SD output. 6 When the camera is connected via HDMI OUT terminal to an external monitor, the video signal output from the HD/SD SDI terminal will be the same as that from the HDMI OUT terminal. 7 When the resolution is 2048x1080, the scan mode is PsF. When the resolution is 1920x1080, the scan mode is interlaced. 8 HRAW only. 9 Video output will automatically switch to HD or SD, depending on the capability of the external monitor. 10 Set [¢ Video Setup] (in mode) or [ 4K/2K/MXF Setup] (in mode) > [SYNC OUT] > [Output] to [HD-Y] (HD component video, luminance signal) or [Composite] (SD analog composite signal).