Canon EOS C500 Instruction Manual - Page 143

Video Output Configuration Video Output Configuration for MXF Mode Refer to the following table for the video output configuration from each terminal during recording and playback. Operating modes: 143 Video configuration Resolution Frame rate 59.94i 29.97P 1920×1080 1440×1080 23.98P 50.00i 25.00P 1280×720 24.00P 59.94P 29.97P 23.98P 50.00P 25.00P 24.00P HD/SD SDI terminal2, 3, 4 HD1 HD ( mode) ( mode) 1080/59.94i 1080/29.97 (P/PsF) 1080/59.94i 1080/23.98 (P/PsF) 1080/50.00i 1080/25.00 (P/PsF) 1080/50.00i 1080/24.00 (P/PsF) 1080/60.00i 720/59.94P 720/29.97P 720/59.94P 720/23.98P 720/50.00P 720/25.00P 720/50.00P 720/24.00P 720/60.00P SD 480/59.94i 576/50.00i - 480/59.94i 576/50.00i - HDMI OUT terminal3, 5 HD SD 1080/59.94i 480/59.94P 1080/50.00i 576/50.00P 1080/60.00i - 720/59.94P 480/59.94P 720/50.00P 576/50.00P 720/60.00P - SYNC OUT terminal6 HD SD 1080/59.94i 480/59.94i 1080/50.00i 576/50.00i 1080/60.00i - 720/59.94P 480/59.94i 720/50.00P 576/50.00i 720/60.00P - 1 Depending on the signal, you can switch between the P and PsF setting (A 147) for output. 2 Set [¢ Video Setup] (in mode) or [ 4K/2K/MXF Setup] (in mode) > [HD/SD SDI] > [Output] to [HD], [SD] or [Off]. 3 You can display zebra patterns on an external monitor during HD output (A 83). Zebra patterns will not be output during SD output. 4 When the camera is connected via HDMI OUT terminal to an external monitor, the video signal output from the HD/SD SDI terminal will be the same as that from the HDMI OUT terminal. 5 Video output will automatically switch to HD or SD, depending on the capability of the external monitor. 6 Set [¢ Video Setup] (in mode) or [ 4K/2K/MXF Setup] (in mode) > [SYNC OUT] > [Output] to [HD-Y] (HD component video, luminance signal) or [Composite] (SD analog composite signal).