Dell PowerConnect 8024 User's Guide - Page 172
RADIUS Accounting Server Configuration, Remove, Apply Changes, System, Management Security, RADIUS
View all Dell PowerConnect 8024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Figure 6-57. RADIUS Server Status 3. To remove a named server, select the check box in the Remove column. 4. Click Apply Changes. The RADIUS server is removed from the list. Configuring RADIUS Server Settings Using CLI Commands For information about the CLI commands that perform this function, see the RADIUS Commands chapter in the CLI Reference Guide. The following table summarizes the equivalent CLI commands you use. Table 6-32. RADIUS Server Commands CLI Command auth-port key msgauth name primary radius-server host show radius-servers Description Sets the port number for authentication requests of the designated radius server. Sets the authentication and encryption key for all RADIUS communications between the switch and the RADIUS daemon. Enables the message authenticator attribute to be used for the RADIUS Authenticating server being configured. Assigns a name to a RADIUS server. Specifies that a configured server should be the primary server in the group of authentication servers which have the same server name. Specifies a RADIUS server host and enter RADIUS Configuration mode. Displays the RADIUS server settings. RADIUS Accounting Server Configuration From the RADIUS Accounting Server Configuration page, you can add a new RADIUS accounting server, configure settings for a new or existing RADIUS accounting server, and view RADIUS accounting server status information. The RADIUS client on the switch supports up to 32 named authentication and accounting servers. To access the RADIUS Server Configuration page, click System →Management Security →RADIUS Accounting Server Configuration in the tree view. 172 Configuring System Information