Dell PowerConnect 8024 User's Guide - Page 750

• Interface - Select the interface for which data is to be displayed or configured from the menu. You must have configured at least one router interface before configuring or displaying data for an MLD Proxy interface and it should not be a MLD routing interface. • Interface Mode - Select enable or disable from the menu to set the administrative status of MLD Proxy on the selected interface. The default is disable. Routing, MLD and Multicast global admin modes should be enabled to enable MLD Proxy interface mode. • Unsolicited Report Interval - Enter the unsolicited time interval value in seconds. The Unsolicited Report Interval is the time between repetitions of a host's initial report of membership in a group. Valid values are from (1 to 260). The default value is 1. Click Apply Changes to send the updated configuration to the switch. Configuration changes take effect immediately. These changes will not be retained across a power cycle unless a save is performed. Configuring MLD Proxy Global Settings Using CLI Commands For information about the CLI command that performs this function, see the following chapter in the CLI Reference Guide: • IPv6 Routing Commands The following table summarizes the equivalent CLI commands for this feature. Table 12-28. IPv6 MLD Proxy Global Commands CLI Command ipv6 mld-proxy ipv6 mld-proxy reset-status ipv6 mld-proxy unsolicit-rprt-interval Description Enables MLD Proxy on the router. Resets the host interface status parameters of the MLD Proxy router. Sets the unsolicited report interval for the MLD Proxy router. MLD Proxy Configuration Summary Use the MLD Proxy Configuration Summary page to view configuration and statistics on MLD proxyenabled interfaces. To display this page, click IPv6 Multicast →MLD →Proxy Interface →Configuration Summary in the navigation tree. 750 Configuring IP Multicast