Dell PowerConnect 8024 User's Guide - Page 97

Device Default Settings To return to device default settings use delete startup-config command at the privileged mode prompt (#), and reboot the device. Once device reloads - it is set with the default settings. console> console>enable console#delete startup-config Startup file was deleted console#reload Management switch has unsaved changes. Are you sure you want to continue? (y/n) y Configuration Not Saved! Are you sure you want to reload the stack? (y/n) y Reloading all switches.. Enabling Remote Management 1. Enter the enable command at the console to enter the Privileged EXEC screen mode as follows: console>enable console# 2. Connect the management station to the switch through one of the Ethernet ports, or through a network connected to the switch, using a CAT5 Cable. This example uses port 1/xg1. 3. Ensure (on the serial console) that the interface status changed to "up" and that the STP status is forwarding (after 30 seconds), as shown below: console# 01-Jan-2000 01:43:03 %LINK-I-Up: Vlan 1 01-Jan-2000 01:43:03 %LINK-I-Up: 1/xg1 01-Jan-2000 01:43:34 %STP-I-PORTSTATUS: Port 1/xg1: STP status Forwarding 4. Enable DHCP on the management interface or out-of-band interface. NOTE: In order to function properly, DHCP cannot not be configured simultaneously on the management and OOB interfaces. a. Enter the config command at the console to enter the Configuration mode as follows: Configuring Dell™ PowerConnect™ 97