Dell PowerConnect 8024 User's Guide - Page 714

The DVMRP Global Configuration page contains the following fields: • Admin Mode - Select Enable or Disable from the drop-down menu. This sets the administrative status of DVMRP to active or inactive. The default is Disable. • Version - The current value of the DVMRP version string. • Total Number of Routes - The number of routes in the DVMRP routing table. • Reachable Routes - The number of routes in the DVMRP routing table that have a non-infinite metric. Setting the DVMRP Admin Mode 1. Open the DVMRP Global Configuration page. 2. Set Admin Mode to Enable or Disable, to turn DVMRP on or off. 3. Click Apply Changes. The DVMRP configuration is saved, and the device is updated. Configuring DVMRP Using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • DVMRP Commands The following table summarizes the equivalent CLI commands for this feature. Table 12-8. DVMRP Global Commands CLI Command ip dvmrp show ip dvmrp ip dvmrp trapflags Description Sets the administrative mode of DVMRP in the router to active. Displays the system-wide information for DVMRP. Enables the DVMRP trap mode. DVMRP Interface Configuration Use the DVMRP Interface Configuration page to configure a DVMRP interface. You must configure at least one router interface before you configure a DVMRP interface. Otherwise you see a message telling you that no router interfaces are available, and the configuration screen is not displayed. To display the page, click IPv4 Multicast →DVMRP →Interface Configuration in the tree view. 714 Configuring IP Multicast