Dell PowerConnect 8024 User's Guide - Page 552
RIP Route Redistribution Configuration, Routing, Router
View all Dell PowerConnect 8024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 552 highlights
Displaying RIP Interface Summary Using CLI Commands For information about the CLI command that performs this function, see the following chapter in the CLI Reference Guide: • Routing Information Protocol (RIP) Commands The following table summarizes the equivalent CLI commands for this feature. Table 9-26. RIP Interface Summary Command CLI Command show ip rip interface brief Description Displays general information for each RIP interface. RIP Route Redistribution Configuration Use the RIP Route Redistribution Configuration page to configure the RIP Route Redistribution parameters. The allowable values for each fields are displayed next to the field. If any invalid values are entered, an alert message is displayed with the list of all the valid values. Static Reject Routes A static reject route is a static route to discard the packets to a particular destination, thereby forcing a black-hole routing behavior for a particular set of IP prefixes. Static reject routes can help prevent a routing loop in the network if a default route is configured on a router. Static reject routes also help protect against a DOS attack on a router with unwanted destination addresses. NOTE: Static reject routes are not redistributed by OSPF or RIP. Starting with software release 3.0, you can select Static Reject as a route type from the Route Type field on the following pages under the Routing →Router menu: • Route Entry Configuration • Configured Routes NOTE: For a static reject route, the next hop interface value is Null0. Packets to the network address specified in static reject routes are intentionally dropped. To display the page, click Routing →RIP →Route Redistribution Configuration in the tree view. 552 Configuring Routing