Dell PowerConnect 8024 User's Guide - Page 204

Figure 6-85. CP - Client Status The CP - Client Status page contains the following fields: • Configuration Name - The drop-down menu lists each CP configured on the switch. To view information about the clients connected to the CP configuration, select the CP configuration name from the list. • MAC Address - Identifies the MAC address of the client. • IP Address - Identifies the IP address of the client. • Interface - Identifies the interface the client used to access the network. • Protocol - Shows the current connection protocol, which is either HTTP or HTTPS. • Verification - Shows the current account type, which is Guest, Local, or RADIUS. Configuring Captive Portal Settings Using CLI Commands For information about the CLI commands that perform this function, see the Captive Portal Commands chapter in the CLI Reference Guide. The following table summarizes the equivalent CLI commands you use to configure Captive Portal. Table 6-40. Captive Portal Configuration Commands CLI Command authentication timeout captive-portal http port https port show captive-portal show captive-portal status block Description Configures the authentication timeout. Enables the captive portal configuration mode. Configures an additional HTTP port for captive portal to monitor. Configures an additional HTTPS port for captive portal to monitor. Displays the status of captive portal. Reports the status of all captive portal instances in the system. Blocks all traffic for a captive portal configuration. 204 Configuring System Information