Dell PowerConnect 8024 User's Guide - Page 237

Trap Flags The Trap Flags page is used to specify which traps you want to enable or disable. When the condition identified by an active trap is encountered by the switch, a trap message is sent to any enabled SNMP Trap Receivers, and a message is written to the trap log. To access the Trap Flags page, click System →Trap Manager →Trap Flags in the navigation tree. Figure 6-112. Trap Flags The Trap Flags page contains the following fields: • Switch Traps - Authentication - Enable or disable activation of authentication failure traps by selecting the corresponding line on the pull-down entry field. The factory default is enabled. - Link Up/Down - Enable or disable activation of link status traps by selecting the corresponding line on the pull-down entry field. The factory default is enabled. - Multiple Users - Enable or disable activation of multiple user traps by selecting the corresponding line on the pull-down entry field. The factory default is enabled. This trap is triggered when the same user ID is logged into the switch more than once at the same time (either via telnet or the serial port). Configuring System Information 237