Dell PowerConnect 8024 User's Guide - Page 448

Viewing DHCP Relay Statistics With CLI Commands For information about the CLI commands that perform this function, refer to the following chapter in the CLI Reference Guide: • L2 DHCP Relay Agent Commands The following table summarizes the equivalent CLI commands for this feature. Table 7-74. DHCP Relay Statistics Configuration Command CLI Command show dhcp l2relay stats clear dhcp l2relay statistics Description Displays statistics for L2 DHCP relay. Clears all dhcp L2 relay statistics. DHCP Relay VLAN Configuration You can enable L2 DHCP relay on a particular VLAN. The VLAN is identified by a service VLAN ID (SVID), which a service provider uses to identify a customer's traffic while traversing the provider network to multiple remote sites. The switch uses the VLAN membership of the switch port client (the customer VLAN ID, or C-VID) to perform a lookup a corresponding S-VID. If the S-VID is enabled for DHCP Relay, then the packet can be forwarded. If the C-VID does not correspond to an S-VID that is enabled for DHCP Relay, then the switch will not relay the DHCP request packet. To access this page, click Switching →DHCP Relay →VLAN Configuration in the tree view. 448 Configuring Switching Information