HP Brio ba200 hp brio ba200, user guide - Page 64
Installing a Drive in the Lower Expansion Bay
View all HP Brio ba200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Installing an Expansion Bay Drive 6 Replace the audio, data and power cables. 7 Replace the cover. Refer to page 46. Installing a Drive in the Lower Expansion Bay 1 Remove the cover. Refer to page 46. 2 Remove the PC's front panel by simultaneously releasing the four lower clips. 3 Rotate the bottom part of the panel gently upwards until the whole panel can be lifted off. 4 Lay the front panel on a flat surface beside the PC. 5 Remove the plastic masking plate from the front panel by prising the retaining tabs open by hand. rear of front panel 6 If the bay has a metal blanking plate, then break it off using a screwdriver. 7 Slide the drive in from the front of the computer. 8 Tighten the three screws that fasten the drive to the bay. You must fit these screws in the holes that have "1" engraved alongside. 58