HP DesignJet D5800 Using Your Printer - Page 42
Take-up reel has been successfully installed
View all HP DesignJet D5800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
16. Fit the loop-shaper into the supports at either side. 17. Use the wind-direction switch on the take-up reel motor to select the winding direction. Setting 1 winds the paper so that the printed image faces in. Setting 2 winds the paper so that the printed image faces out. The front panel shows you the correct setting based on the winding-direction decision you made earlier. 18. Press the OK button on the front panel. The Take-up reel has been successfully installed message appears. 19. The following image shows how the printer looks when it is operating. As paper is fed from the printer, it drops down in a loop and then up into the take-up reel spindle. NOTE: While the take-up reel is operating, make sure that the take-up reel sensors are not blocked. NOTE: The cutter is disabled when the take-up reel is in use. 34 Chapter 4 Handle the paper ENWW