HP LH4r Installation and configuration of the HP NetRAID, NetRAID-1 and NetRAI - Page 159
Sample Alternate Switch Settings, Mass Storage Cables
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Appendix D Sample Alternate Switch Settings Cabling Diagrams Mass Storage Cables Some of the optional mass storage configurations require additional cables. This table lists the cables used in configuring mass storage devices for this HP NetServer. Only these HP cables and adapters are supported: Cabling Diagram Label C52 C82 D6 F6 I2C T Location System backplane (or NetRAID controller) SCSI connector to hot swap backplane System backplane SCSI connector to upper shelf SCSI devices System backplane IDE connector to IDE devices (CD-ROM or other) System backplane FDD connector to diskette drive I2C cable, system backplane to hot swap backplane Description 3-connector, Wide (68-pin) SCSI cable 2-connector, Wide 68-pin SCSI cable with built-in terminator 3-connector IDE cable 2-connector flexible disk cable 2-connector I2C (3-pin) cable SCSI terminator built into board or cable 151