HP NetServer AA 4000 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 216

Chapter 13 MtcMon Messages IOPn.MtcMon FRU: IOPx CEy interconnect fault. Variables x - the ID of the IOP with the interconnect fault y - the ID of the CE with the interconnect fault Severity Error Description An unqualified failure has occurred in the communications path between the specified IOP and CE. The path includes: the IOPx MIC, the CEy MIC, and the cabling between these components. Action • Check the cabling between the CE and the IOP. Make sure that both ends of each cable are securely fastened to the appropriate connector. • Examine the connection state icons on the Endurance Manager display. Verify that the MICs are properly connected. • Run the MIC Connectivity Test in the MIC BIOS utility to validate that the MIC paths on the CE and the IOP are functioning properly. • If the condition persists: - Replace the cable between the CE and IOP MICs to determine if this cable is the source of the fault. - Replace the MIC on the CE and then the MIC on the IOP to determine if either MIC is the source of the fault. IOPn.MtcMon FRU: IOPx IOP-IOP Link (IL) netcard capability, cabling, or remote netcard. Variables x - the ID of the IOP removed from the Endurance server Severity Error Description This message is generated when an IOP detects an IL failure that removes the specified IOP from the Endurance server. This message indicates that an error was detected on the IL (IOPto-IOP path) which includes the Ethernet drivers, the network cards, and the cabling between the two. Related Messages IOPn.MtcMon FRU: IOP1 IOP2 interconnect fault. Action • Examine the event logs on both IOPs to make sure that both IOPs are functioning properly. • Check the IOP-to-IOP Ethernet cabling. • Perform any diagnostics available on the network cards to make sure that they are functioning properly. 206