HP NetServer AA 4000 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 250

Chapter 13 MtcMon Messages IOPn.MtcMon status: CEx could not be booted because the SCSI boot driver has not registered with the Monitor on IOPy. Variables x - the ID of the CE that could not be booted y - the ID of the IOP driving the boot process Severity Error Description A CE issued a boot request to an IOP that does not have the Endurance SCSI Provider loaded and active. If both IOPs are active, this message should occur on both simultaneously. Hardware/Software This message is usually due to a software configuration error that results in the Endurance SCSI Provider not being loaded. It can also be due to a failure of the SCSI Provider. Action • During Endurance server configuration, at least one mirrored SCSI disk must be configured. If this is not the case, reconfigure the IOP (or IOPs) and reboot. Refer to Chapter 9 in HP NetServer AA Solution Administrator's Guide for information about how to reboot an IOP. • Examine the event log to determine if the Endurance SCSI Provider loaded properly, and if appropriate, repair any problems indicated. The CE boots when the IOP reboots and has a properly loaded SCSI Provider. IOPn.MtcMon status: CEx could not be removed or disabled because CE synchronization is currently in progress. Variables x - the ID of the CE that could not be removed or disabled Severity Warning Description This message is generated when the CE is active and you issued a CE Remove or CE Disable command while CE synchronization was in progress. These operations cannot be performed during CE synchronization. Hardware/Software This message is generated as a result of a software condition. Action The CE Remove or CE Disable command was not performed. Reissue the command when the CE synchronization process has completed. 240