HP NetServer AA 4000 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 258

Chapter 13 MtcMon Messages IOPn.MtcMon status: Client registration failed on the local IOP. Client ID = x. Variables x - the ID of the client that failed the registration process with the Monitor: Client ID Client Description 2 Floppy 4 Serial Provider 8 Keyboard/Mouse Provider 10 Endurance Event Provider 11 Endurance Device Synchronization Layer 12 Endurance Monitor C Endurance Ethernet Provider E Endurance SCSI Provider Client Image Name MtcFloP.Sys MtcSerP.Sys MtcKmP.Sys MtcEvtp.Sys MtcDsl.Sys MtcMon.Sys MtcEthp.Sys MtcScsip.Sys Severity Description Hardware/Software Action Error When a Monitor client is loaded, it registers itself with the Monitor. If the registration is not valid, this message is generated. The registration fails if any of the following are detected: • The client ID is not in the Monitor's ClientList registry parameter. • The client is already registered with the Monitor. • The client specifies an invalid parameter in its registration information. • The client ID provided during the registration attempt is not valid. This message is due to either an Endurance server software configuration error or an Endurance server internal error. • The client ID specifies which Endurance software component could not be registered. The Monitor's ClientList Registry parameter should be examined to determine if the given client should be registered with the Monitor. If the client ID does not appear in this list, it should be added to the list or it should not be loaded. • Reinstall Endurance software on the IOP. • If the condition persists, issue an IOP Disable Operation command and run the Endurance server with a single IOP. Contact your service provider for assistance. 248