HP NetServer AA 4000 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 25
Table 1-5HP NetServer AA Message Summary, Prefixed Messages, Continued
![]() |
View all HP NetServer AA 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 1 Introduction Table 1-5HP NetServer AA Message Summary - Prefixed Messages (Continued) Message Page IOPn.MtcDsl status: An invalid component type was encountered (offendingValue). IOPn.MtcDsl status: An invalid DSL packet ID was encountered (offendingValue). IOPn.MtcDsl status: An invalid IOP state was encountered (offendingValue). IOPn.MtcDsl status: An invalid logical device operation type was encountered (offendingValue). IOPn.MtcDsl status: An invalid packet descriptor was encountered. IOPn.MtcDsl status: An invalid reset reason code was encountered (offendingValue). IOPn.MtcDsl status: An invalid resync flush state was encountered (offendingValue). IOPn.MtcDsl status: An invalid subprovider ID was encountered (offendingValue). IOPn.MtcDsl status: An invalid transaction ID was encountered (offendingValue). IOPn.MtcDsl status: Invalid device entries in the IOP's configuration were pruned. This indicates an improperly set up device configuration. This problem may have occurred due to hand modifications of the Windows NT Registry. The problem may be fixed by re-running the HP NetServer AA Configuration Utility. IOPn.MtcDsl status: Physical device phyDevName of logical device logDevName on IOPx is offline. IOPn.MtcDsl status: Physical device phyDevName of logical device logDevName on IOPx is online. IOPn.MtcDsl status: Provider provName experienced an internal failure. IOPn.MtcDsl status: The IOPs could not be joined because IOP 1 has a different device configuration than IOP 2. This problem may be fixed by comparing the configurations and making them consistent. IOPn.MtcDsl status: Unable to allocate a callback descriptor. IOPn.MtcDsl status: Unable to allocate a callback worker thread. IOPn.MtcDsl status: Unable to find a flush descriptor on the global flush list. IOPn.MtcDsl status: Unable to initialize the DSL. IOPn.MtcDsl status: Unable to run provider's callback routine provName. IOPn.MtcDsl status: Unable to start a full flush due to an internal software error. IOPn.MtcEthP status: A call to NdisRequest timed out. page 101 page 102 page 102 page 103 page 103 page 103 page 104 page 104 page 104 page 105 page 105 page 106 page 106 page 106 page 107 page 107 page 107 page 108 page 108 page 108 page 115 15
![](/manual_guide/products/hewlettpackard-netserver-aa-4000-hp-netserver-aa-6200-solution-release-30-messages-13dd408/25.png)