HP NetServer AA 4000 HP Netserver AA Solution Installation Guide v4.0 SP1 - Page 71
SplitSite Installation, Action
View all HP NetServer AA 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
SplitSite Installation To install in a SplitSite configuration, starting at the site of Tuple1: Step Action 1 Install all software (Windows and Endurance) on IOP1. 2 Use the Endurance Manager to disable CE1 and IOP1 (tuple 1). 3 Copy the Endurance configuration to a floppy disk. 4 Boot IOP1 in Operational Endurance I/O Processor Mode. 5 Use the Endurance Manager to partition the CE boot disk on IOP1. 6 Power on CE1. 7 Go to the site of Tuple 2. 8 Install all software (Windows and Endurance) on IOP2. 9 Load the Endurance configuration file from the floppy you created on IOP1. 10 Correct the Ethernet addresses for the IOP2 redirected network card. 11 Use the Endurance Manager to enable IOP1. 12 Verify that IOP1 joins successfully, and correct any problems. 13 Use the Endurance Manager to disable IOP1. 14 Boot IOP2 in Offline Endurance I/O Processor Mode. 15 Install the CE software as described in this manual, replacing references to CE1 with CE2, and IOP1 with IOP2. 16 Complete the CE software installation. 17 Use the Endurance Manager to enable IOP1. 18 Verify that IOP1 joins successfully. 19 Use the Endurance Manager to enable CE1. 20 Verify that CE1 synchronizes successfully. If it is necessary to complete a single tuple installation before you begin the installation on the second tuple, simply skip the step of installing IOP2 before installing the CE software. Note: The CE software is installed on only one CE. You can install the software on either CE. Installing Windows and the Endurance Software 3-33