HP ProLiant DL280 Configuring Arrays on HP Smart Array Controllers Reference G - Page 88

Error code 2053 2056 2059 2064 2817 2818 2819 2821 2823 2824 2825 2826 2827 2828 2829 2830 2831 2832 2833 2834 Error message Comment or clarification successfully. Too many coinciding expansion, migration, The new configuration requires more or extension operations transformations than are possible at one time. For example, you cannot expand a logical volume and transform its RAID level at the same time. Controller does not support license keys The controller does not support license key entry or deletion. Invalid license key The entered license key is not a valid license key. Controller does not support SSP The controller does not support SSP functions. Invalid Action The requested actions are invalid, for example, combining -reset with capture mode. Invalid Method The method must be either Custom or Auto. Invalid Controller An invalid controller value was specified. No controllers detected No controllers were detected. This error applies to Input mode only. Invalid Rebuild Priority The specified rebuild priority is not supported. Invalid Expand Priority The specified expand priority is not supported. This error also occurs if the controller does not allow expansion, and therefore does not support expand priority. Invalid Array The array ID is invalid. Array not specified The Array command is missing from the script file. Some commands were found that require an Array to be specified. New Array ID does not match the next available Array ID. The array ID in the script file does not match the array ID of the next available array. For example, if the configuration has an Array A and the input file specifies Array C (without Array B), then the script generates this error. New Array ID already exists The array ID specified in the script file (in Configure mode) already exists in the configuration. Configure mode can only create new arrays. Cannot create Array The controller will not allow a new array to be created, either because the controller has no unassigned physical drives attached or because the maximum number of arrays or logical drives has been reached already. Cannot expand Array The Array could not be expanded, either because the controller does not support expansion, or the current configuration does not allow expansion to occur on the array. Cannot change Array Spare The spare state of the array could not be changed. This error can occur when you attempt to add or drop a spare and the current configuration does not allow a spare state change for the array. Invalid physical drive A specified physical drive is not a valid physical drive, or it cannot be placed in the array. Invalid Spare A specified spare is not a valid spare drive, or it cannot be placed in the array as a spare. Invalid logical drive The logical drive ID is not valid. HP Array Configuration Utility 88